Manitowoc CVD0675 User Manual

–130–
Water System Checklist
A water-related problem often causes the same
symptoms as a refrigeration system component
malfunction.
Example: A water dump valve leaking during the
Freeze cycle, a system low on charge, and a starving
TXV have similar symptoms.
Water system problems must be identified and
eliminated prior to replacing refrigeration components.
Possible Problem List
 Corrective Action List
Water area (evaporator) is dirty
 Clean as needed
Water inlet pressure not between 20 and 80 psig
 Install a water regulator valve or increase the water
pressure
Incoming water temperature is not between 35°F
(1.7°C) and 90°F (32.2°C)
 If too hot, check the hot water line check valves in
other store equipment
Water filtration is plugged (if used)
 Install a new water filter
Water dump valve leaking during the Freeze cycle
 Clean/replace dump valve as needed
Vent tube is not installed on water outlet drain
 See Installation Instructions
Hoses, fittings, etc., are leaking water
 Repair/replace as needed
Water fill valve or float is stuck open or closed
 Clean/replace as needed
Water is spraying out of the sump trough area
 Stop the water spray
Uneven water flow across the evaporator
 Clean the ice machine
Water is freezing behind the evaporator
 Correct the water flow
Plastic extrusions and gaskets are not secured to
the evaporator
 Remount/replace as needed

Manitowoc CVD0675 Specifications

General

Brand	Manitowoc
Model	CVD0675
Category	Ice Maker
Language	English