Part Number STH038 5/12 135
PROGRAMMING A REPLACEMENT CONTROL
BOARD
Indigo™ replacement control boards require the Model
and Serial number to be entered to activate the
appropriate look up tables for operation and
diagnostic. This can be done two different ways, USB
Setup or Manual Setup.
USB Setup - Applicable when the control board is
operational and has a mechanical issue such as a
sticking relay. The asset data is transferred to the
replacement control board from the faulty control
board. Refer to page 133 “Exporting Data To A Flash
Drive” before installing the replacement board.
Follow the instructions on page 131 “Upgrading
Firmware with a Flash Drive or Transferring Setup
Data To Multiple Machines”.
To Next Page
Loading...
Need help?
General