It is the responsibility of the equipment owner to
perform a Personal Protective Equipment Hazard
Assessment to ensure adequate protection
during maintenance procedures.
Two or more people are required to move this
equipment to prevent tipping.
Some 50 hz models may contain up to 150 grams of
R290 (propane) refrigerant. R290 (propane) is
flammable in concentrations of air between
approximately 2.1% and 9.5% by volume (LEL lower
explosion limit and UEL upper explosion limit). An
ignition source at a temperature higher than 470°C
is needed for a combustion to occur. Refer to
nameplate to identify the type of refrigerant in your
equipment. Only trained and qualified personnel
aware of the dangers are allowed to work on the
equipment.
To Next Page
Need help?
General