ENGLISH
20
BASIC
CONNECTIONS
BASIC OPERATION
ADVANCED
CONNECTIONS
SETUP
ADVANCED
OPERATION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTION
ADVANCED
CONNECTIONS
Note:
• You can use surround back speaker terminals as ZONE SPEAKER A. terminals or SPEAKER C terminal when you
are not using surround back speakers.
CONNECTING FOR SPEAKER C USE (BI-AMP CONNECTION)
A bi-amp connection is possible with speakers that have two sets of inputs (for treble and bass).
This allows you to drive the treble and bass units with separate channel amps, which enables better sound
quality. Connect the speakers as shown in the fi gure. Set the SPEAKER C selector switch on the rear panel
to ON.
Notes:
• If incorrectly connected, a protective circuit in the unit will trip and set the unit to standby. (The STANDBY
indicator will fl ash.) In such case, recheck the connections between the speakers and the unit.
• Turn power to the unit off before changing the setting of the SPEAKER C selector switch.
R
FRONT A OR B,CENTER, SURR,SURR BACK : 6-8 OHMS
FRONT A OR B,CENTER, SURR,SURR BACK : 6-8 OHMS
FRONT A OR B,CENTER, SURR,SURR BACK : 6-8 OHMS
FRONT A OR B,CENTER, SURR,SURR BACK : 6-8 OHMS
RIGHT
SPEAKER
LEFT
SPEAKER
CONNECTING AN EXTERNAL POWER AMPLIFIER
The PREOUT jacks are for connecting external power amplifi er.
Be sure to connect each speaker to the corresponding external power amplifi er.
R
FRONT A OR B,CENTER, SURR,SURR BACK : 6-8 O
HFRONT A OR B,CENTER, SURR,SURR BACK : 6-8 OHMS
8CH POWER AMPLIFIER MM8003
8CH POWER AMPLIFIER MM800 3
L
R
FRONT SURR.
SURR.
BACK
CENTER
RL
R L R L R L
RL RL
Power
Amplifer
Center
Front
Left
Front
Right
Surround
Left
Surround
Right
Surround
Back Left
Surround
Back Right
Powered
Subwoofer
SR6003U01ENG24.indd20SR6003U01ENG24.indd20 08.8.11:06:58PM08.8.11:06:58PM