29 30
4.18 NCV Measurement
1) Turn the meter to NCV mode.
2) Place the meter top close to the conductor. When
test voltage is greater than 110 Vac (RMS), when the
meter is close to the conductor, the meter induction
voltage indicator will turn on and the buzzer will give
an alternating high-low alarm sound.
1: Even there is no indication, voltage may exist still.
Don't use non-contact voltage detector to judge
whether there is voltage in the wire. Detection
operation could be affected by socket design,
insulation thickness, type and other factors.
2: When inputting voltage on the meter input terminal,
due to the existence of the induced voltage, voltage
induction indicator also may light.
3: External sources of interference (such as flashlight,
motor, etc.) may incorrectly trigger non-contact
voltage detection.
Note:
5. Maintenance
5.1 Replace Battery
Before opening the meter battery cover, remove
probe from the circuit to be measured to avoid
electric shock.
Warning
1) When the battery symbol “ ” appears, the battery
should be replaced immediately.
2) Unscrew the fastening screw of the battery cover
and remove the cover.
3) Replace battery.
4) Put the battery cover back as before.
The battery polarity can't be reversed.
Note:
5.2 Replace Probe
When replacing probe, replaceit with another
identical probe or one with the same level of
performance. The probe should be in good
condition. Probe level: 1000V, 10A.
Warning
If the probe is damaged, such as naked metal wire,
replace the probe.
6. Accessories
Level: 1000V 10A
One pair
1)
2)
3)
1 PC
Probe
6F22 9VOLTS
Battery
Operation Manual
To Next Page
Loading...
Need help?
General
