16
15
3.2.11 Capacitance
Accuracy
Resolution
Measuring range
±(3.0% reading + 5 digits)
6.000nF
- Overload protection: 250V DC or AC (RMS)
60.00nF
600.0nF
6.000µF
60.00µF
600.0µF
6.000mF
60.00mF
0.001nF
0.01nF
0.1nF
0.001µF
0.01µF
0.1µF
0.001mF
0.01mF
3.2.12 Diode Test
Function Resolution
Measuring range
- Forward DC current is about 1mA
- Overload protection: 250V DC or AC (RMS)
0.001V
Display approximate diode
forward voltage value
FunctionResolution
Measuring range
3.2.10 Circuit Continuity Test
- Overload protection: 250V DC or AC (RMS)
0.1Ω
If the resistance of circuit to
be measured is less than
50Ω, the meter's built-in
buzzer may sound.
In the process of measurement, if reading hold is
required, then press “HOLD” key to release
reading hold.
4. Operating Guidance
4.1 Reading Hold
4.2 Manual Measuring Range
RANGE key is automatic/manual measuring range key
to trigger mode. The preset function is automatic
measuring range. Press to switch to manual measuring
range. In the manual measuring range mode, click
once to jump to upper grade, till to the top grade, then
continue to press this key to jump back to automatic
measuring range.
In the frequency measurement state, manual
measuring range button is invalid.
Note:
4.3 Back Light and Clamp Head Light
1) In the process of measurement, if ambient light is
too dark to read, press “B.L/RANGE” key about 2
seconds to turn on the backlight. The backlight will
automatically turn off after about 10 seconds.
2) During this period, pressing “B.L/ HOLD” key more
than two seconds will turn off backlight.
3) In the current grade, the meter will turn on backlight,
and at the same time it will turn on clamp head light.
Backlight luminophor is LED with high working
current. Although the meter has no timing circuit, if
backlight is used often, it will shorten battery life.
Therefore, minimize use of the backlight to conserve
battery power.
To Next Page
Loading...
Need help?
General
