03 04
1.3 Mark
Note (Important safety information. Refer to
the operation manual)
Dangerous electric conductor.
Double insulation protection (class II)
CAT III According to pulse voltage tolerance
protection level provided by IEC 61010-1
standard overvoltage (installation) level III and
pollution degree 2.
The meter complies with EU standard
Grounding
1.2.11 Do not use the meter in explosive gas, vapor or
dusty environment.
1.2.12 If you find any abnormal phenomena or failure
on the meter, stop using the meter immediately.
1.2.13 Do not use the meter unless the meter bottom
case and the battery cover are completely
fastened in original places.
1.2.14 Don't store or use the meter in direct sunlight,
high temperature and high humidity.
C
This product has been tested to the requirements
of CAN/CSA-C22.2 No. 61010-1, second edition,
including Amendment 1, or a later version of the
same standard incorporating the same level of
testing requirements”.
CONFORMS TO UL STD. 61010-1, IEC
61010-2-032 CERTIFIED TO CSA STD.
C22.2 No. 61010-1 and 61010-2-032
1.4.1 Don't try to open the meter bottom case to adjust
or repair. Such operations only can be made by
technicians who fully understand the meter and
electrical shock hazard.
1.4.2 Before opening the meter bottom case or battery
cover, remove probe from the circuit to be measured.
1.4.3 To avoid incorrect readings and possible electric
shock, when " " appears on the meter display,
replace the battery immediately.
1.4.4 Clean the meter with damp cloth and mild
detergent. Do not use abrasives or solvents.
1.4.5 Turn power off when the meter is not used, and
switch the measuring range to OFF position.
1.4.6 If the meter is not used for long time, remove the
battery to prevent damage to the meter.
1.4 Maintenance
2. Description
- The meter is a portable, professional measuring
instrument with LCD display and back light for easy
reading by users. Measuring range switch is operated
by single hand for easy operation. The meter has
overload protection and a low battery indicator. It is
an ideal multifunction meter for professionals,
factories, schools, fans and family use.
- The meter is used for measuring AC current, DC
current, voltage, DC voltage, frequency, duty ratio,
resistance, capacitance measurement and circuit
connection, diode test and non-contact voltage
detection.
- The meter has automatic measuring range and
manual measuring range.
- The meter has reading hold function.
To Next Page
Loading...
Need help?
General
