To avoid possible electric shock or personal injury, follow these
guidelines:
WARNING
●
●
●
●
●
●
●
●
Do not use the meter if it is damaged. Before you use the
meter, inspect the case. Pay particular attention to the insulation
surrounding the connectors.
Inspect the test leads for damaged insulation or exposed metal.
Check the test leads for continuity. Replace damaged test leads
before you use the meter.
Do not use the meter if it operates abnormally. Protection may
be impaired. When in doubt, have the meter serviced.
Do not operate the meter where explosive gas, vapour, or dust is
present.
Do not apply more than the rated voltage, as marked on the
meter, between the probes or between any probe and earth
ground.
Before use, verify the meter's operation by measuring a known
voltage.
When servicing the meter, use only specified replacement parts.
Use caution when working with voltage above 30 V AC RMS, 42
V peak, or 60 V DC. Such voltages pose a shock hazard.
SAFETY INFORMATION
The multimeter has been designed according to IEC 61010 concern-
ing electronic measuring instruments with a measurement category
(CAT III 600V) and pollution degree 2.
2
WARNING
To Next Page
Loading...
Need help?
General
