Matrix 7xe User Manual

43
9.3 T7XE TFT-LCD MODULE REPLACEMENT
CHAPTER 9: PART REPLACEMENT GUIDE
1. Remove the UCB as outlined in Section 9.2.
2.
Remove the 12 screws holding on the Reinforce Set (Figure A).
3. Cut the two ties on the fixing plate (Figure B).
4.
Remove the fixing plate set from the console cover (Figure C).
5.
Remove the 4 screws
holding on the TFT- Panel (Figure D).
6. Unplug the Inverter cable and LVDS cable (Figure E).
7.
Note: There are two holes on the panel fixing plate--the upper hole is for 7xe and the
lower hole is for T7xe (Figure F).
FIGURE DFIGURE C
FIGURE BFIGURE A
FIGURE FFIGURE E

Matrix 7xe Specifications

General

Brand	Matrix
Model	7xe
Category	Music Mixer
Language	English