Matrix A7X-04 User Manual

32
8.3 CONSOLE ERROR CODES
CODE DESCRIPTION SOLUTION
0x0140 When the UCB implements an incline command, the incline has no
action for 5 seconds.
Replace the Incline Motor or LCB.
0x0142 Theinclinepositionhasadifferenceofover30%andisnotreduced
within 3 seconds.
Look for misalignment of the Incline
Motor, replace if needed.
0x0145 Self powered units only - incline stops when the LCB battery
capacity is too low or the RPMs are not high enough (<70 RPM).
Replace the LCB.
0x0441 When the UCB implements a command, the LCB is not receiving. Check the console cable connections,
update the LCB software, or replace the
LCB or UCB as needed.
0x01A0 Left incline motor disconnected for 3 seconds. Check the connection of the left incline
motor cables at the LCB. Replace the
left incline motor or LCB as needed.
0x01A1 Incline calibration is over 80 seconds or does not complete. Replace the LCB or Incline Motor
0x01A7 The incline is short circuited or over current. Look for misalignment of the Incline
Motor, replace if needed.
0x01AC Generator or resistor has an open circuit, short circuit, or the current
is over 3.7 Amps for 1 second.
Check the connection of the generator
and resistor, replace the generator or
resistor as needed.
0X01AE Battery over charge current or battery short circuit Replace the LCB.
0X01AF The power resistor is disconnected. Check the connection of the resistor at
the LCB. Replace the LCB if needed.
0x01B2 The incline motor has no action or current. Replace the incline motor.
0x0201 LCB battery low voltage (battery voltage < 11.2V). Plug in the machine for AC charge.
Temporarily stop using incline.
0x0247 LCB fail (flash data error). Replace the LCB.
0x0248 Battery disconnection or fail (the battery voltage is less than 8V).. Check that the battery is connected. If
it is, replace the battery.
0x02AB Machine type error. Set the Machine Type and LCB.
0x02B4 Resistance type error. Set the Machine Type and LCB.
0x03A5 Failed to load program. Usually means the software file is
corrupt. Try upgrading the software or
replace the console if needed.
0x03A6 Failed to run program. Usually means the software file is
corrupt. Try upgrading the software or
replace the console if needed.
0x03A7 Failed to load VA package files. Check to see if the SD card is mounted
correctly and that there are no corrupt
video files present. Replace the VA
board if needed.
0x03A8 Machine type setting is not matching the LCB. Set the correct Machine Type for the
console and LCB in Manager Mode.
0x04A0 If the LCB does not return a message to the UCB within 3 seconds. Check the console cable connections,
replace the LCB or UCB as needed.
0x04B0 UCB no communication response. Check the connections of the console
cable at the console and LCB. Replace
cc, console, or LCB as needed.
CHAPTER 8: TROUBLESHOOTING

Matrix A7X-04 Specifications

General

Brand	Matrix
Model	A7X-04
Category	Elliptical Trainer
Language	English