Matrix S-Drive User Manual

3
cHaPTer 2: imPorTanT SafeTy inSTrUcTionS
2.2 before GeTTinG STarTeD
locaTinG THe UniT
Placethetreadmillonalevelandstablesurfaceawayfromdirectsunlight.TheintenseUVlightcancausediscolorationontheplastics.Locate
your treadmill in an area with cool temperatures and low humidity. Please leave a clear zone behind the treadmill that is at least the width of the
treadmillandatleast79”(2000mm)long.Thiszonemustbeclearofanyobstructionandprovidetheuseraclearexitpathfromthemachine.
Foreaseofaccess,thereshouldbeanaccessiblespaceonbothsidesofthetreadmillofatleast24”(600mm)toallowauseraccesstothe
treadmill from either side. Do not place the treadmill in any area that will block any vent or air openings. The treadmill should not be located in a
garage, covered patio, near water or outdoors.
0.6 m
(2 ft)
0.6 m
(2 ft)
0.6 m
(2 ft)
2
m (79”)
0.3
m (1 ft)
levelinG THe eqUiPmenT
It is extremely important that the levelers are correctly adjusted for proper operation. An unbalanced treadmill may cause belt misalignment or other
issues.Useofalevelisrecommended.
Onceyouhaveplacedthetreadmillwhereyouintendtouseit,raiseorloweroneorbothoftheadjustablelevelerslocatedonthebottom-frontof
the frame.
ProPer USaGe
The treadmill can be used in two modes: sled or walk/sprint. To use the treadmill in sled mode, remove the harness so the user has access to
the upper and lower sled handlebars. To use the treadmill in walk / sprint mode, connect the harness and adjust by using the instructions below.
Emergency dismount can be done by grabbing the front or side handlebars and jumping with both feet on the side rails.
SleD moDe
ProPer USaGe
Walk / SPrinT
ProPer USaGe

Matrix S-Drive Specifications

General

Brand	Matrix
Model	S-Drive
Category	Fitness Equipment
Language	English