Specifications
2 Pipes System Specification ( 220V ~ 240 V- 50 Hz)
Model MCW200C MCW300C MCW400C MCW600C MCW800C MCW1000C MCW1200C
High m
3
/h 410 550 770 1060 1450 1640 2070
Medium m
3
/h 340 420 520 850 1180 1360 1760
Air flow
Low m
3
/h 230 350 390 710 920 1100 1510
W 1500 2300 2850 4400 5410 6240 8010
Total
Btu/h 5110 7840 9720 15010 18450 21290 27330
W 3680 5200 7450 10060 13200 14900 19370
Cooling
Capacity
Sensible
Btu/h 12550 17740 25420 34320 45040 50840 66090
Heating Capacity W 2240 3300 4450 6220 7900 9120 10810
Water Flow l/min(m
3
/hr) 7(0.41) 10(0.57) 13(0.78) 19(1.08) 24(1.39) 26(1.56) 32(1.92)
Head Loss kPa 14.6 12.0 21.6 38.2 18.4 21.0 32.7
Fan
Type Centrifugal fan (forward-curved galvanized steel fan wheels)
Number of Fans 1 1 2 2 3 3 4
Fan Housing Galvanized steel
Coil
Type Seamless copper tube mechanically bonded to configurated aluminium fin
Routine Testing Pressure Pressure test: 3.0MPa for 1 minute; leakage test: 1.6MPa for 5 minutes
Motor
Type Split-capacitor motor with ball bearing
Number of Motors 1 1 1 1 2 2 2
Rated Voltage 220-240V~
Rated Frequency 50Hz
0 Pa
W
22 33 45 65 100 105 133
Rated Input 30 Pa
W
27 58 74 120 165 177 237
power 60 Pa
W
41 65 83 140 197 215 280
80 Pa
W
44 79 85 148 200 220 283
Insulation Class E
Pipe Connection Rc3/4
Drain Pipe R 3/4
Length mm 714 884 1014 1214 1464 1564 1824
Width mm 490 (without Plenum) / 556 ( with Plenum)
Dimension
Height mm 251
Net Weight kg 19 22 26 30 41 44 46
Net Weight (Plenum) kg 20 23 28 33 44 48 50
Conditions:
Cooling Capacity: Entering air temp.27℃ (DB*),19.5(WB**); Entering water temp. 7ºC, Leaving water temp. 12ºC
Heating Capacity: Entering air temp. 21℃(DB); Entering water temp. 60ºC, the same amount of water flow with cooling.
Air Flow: Under dry coil conditions, fan speed high weight: Not include packing
* DB: Dry Bulb **WB: Wet Bulb
Note: The suggested range of the entering water temperature is 5℃-10℃ while cooling. To make sure the unit run normally for long
time, the entering water temperature should not be more than 60℃. Water pressure of the unit should not be more than 1.3MPa.
Page 6
To Next Page
Loading...
Need help?
General
