McQuay MDS Service Manual

MCQUAY Service Guide Book Handset Operating Guide
14
4.7 SLM3
Operation Guide
1. “
ON/OFF” Switch
2. Temperature Setting
• Setting range are between 16°C to 30°C
(60°F to 80°F).
3. Operation Modes
• Press the “mode” button for select the
type of operating mode.
-Cooling Only: COOL, DRY, FAN
-Heat Pump: AUTO, COOL, DRY,
HEAT, FAN
• AUTO mode is represented by both
COOL and HEAT LED light on.
4. Fan Speed Selection
• Press the button until the desired fan
speed is achieved.
5. Timer
• Press the set button to select the switch
timer of the air conditioner unit (the setting
range is between 1 to 15 hours).
6. “SLEEP” Mode
• This function can only be activated under
“cool” or heating mode operation. When it
is activated under “cool” mode operation,
the set temperature will increase 0.5°C
after 30 minutes, 1°C after 1 hour and 2°C
after 2 hours. If it is activated under
“HEAT” mode operation, the set
temperature will be decreased 0.5°C after
30 minutes, 1°C after 1 hour and 2°C after
2 hours.
7. Air Swing
• Press button to activate the automatic air
swing function.
8. Sensor
• Infra red sensor to receive signals from
wireless controller.
9. LED Display
• To display the set temperature (in °C) and
timer delay setting (in hours).
10. Transmission Source

McQuay MDS Specifications

General

Brand	McQuay
Model	MDS
Category	Air Conditioner
Language	English