48
Getting started
Driving
Single wipe
왘 Press switch briefly in the direction of
arrow 1.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
왘 Push switch in the direction of arrow 1
past the resistance point.
The windshield wiper operates with
washer fluid.
Information on filling up the washer reser-
voir can be found in the "Operation" sec-
tion (
컄 page 267).
Problems while driving
The engine runs erratically and misfires
ì•« An ignition cable may be damaged.
ì•« The engine electronics may not be op-
erating properly.
ì•« Unburned gasoline may have entered
the catalytic converter and damaged it.
왘 Give very little gas.
왘 Have the problem repaired by an au-
thorized Mercedes-Benz Center as
soon as possible.
!
If leaves, snow, etc. block the wind-
shield wipers, switch off the wipers.
ì•« For safety reasons, withdraw key
from starter switch. Remove block-
age.
ì•« Turn the windshield wipers on
again.
If windshield wipers fail to function at
all in switch position I,
ì•« Set the combination switch to the
next highest wiper speed.
ì•« Have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center.
To Next Page
Loading...
Need help?
General
