125
Controls in detail
Control system
Setting locator lighting
During darkness, the following lamps will
come on when the exterior lamp switch is
in position
U, the locator lighting fea-
ture is activated, and the vehicle is un-
locked by remote control:
ì•« the parking lamps
ì•« the tail lamps
ì•« the license plate lamps
ì•« the front fog lamps
To activate locator lighting:
왘 Make sure that the locator lighting fea-
ture is set to
ON
(see below).
왘 Turn the exterior lamp switch to posi-
tion
U.
The locator lighting switches off when the
driver’s door is opened. It switches off au-
tomatically after a period of approximately
40 seconds.
왘 Move the selection marker with button
æ or ç to the
Lighting
sub-
menu
왘 Press button j or k repeatedly
until you see this message in the left
display:
Locator lighting
.
The selection marker is on the current
setting.
왘 Press æ or ç to select the de-
sired setting.
The locator lighting will be switched on
or off.
Setting night security illumination
(Exterior lamps delayed switch-off)
Use the
Headlamps delayed switch-off
function to set whether and for how long
you would like the exterior lamps to illumi-
nate during darkness after all doors are
closed. When the delayed switch-off fea-
ture is activated and the exterior lamp
switch is in position
U, the following
lamps will remain lit after you remove the
key from the starter switch:
ì•« the parking lamps
ì•« the tail lamps
ì•« the license plate lamps
ì•« the front fog lamps
To activate night security illumination:
왘 Select delayed switch-off period (see
below).
왘 Turn the exterior lamp switch to posi-
tion
U.