162
Control systems
COMAND telephone*
왘 Select number to be overwritten.
COMAND overwrites the selected num-
ber with the new data.
Adding a telephone number to an
address book entry
왘 Select address book entry
(
컄 page 157).
왘 Select “Options” “Add Number”.
왘 Selecting a number category:
Select a category, e.g. “Home”.
왘 Selecting a telephone category:
Select a category, e.g. “Land Line”.
왘 Confirming selection: Select “Save”.
If four numbers are saved for the entry
in the selected number category, a
prompt will appear asking whether one
of the existing numbers should be over-
written.
왘 Select “Yes” or “No”.
If you select “Yes”, a selection list
will appear containing the four ex-
isting numbers.
왘 Select number to be overwritten.
The input menu appears with the
data field for entering the new tele-
phone number.
왘 Entering digits: Select all digits one
by one from the input characters.
왘 Moving cursor in the data field:
Select Y or Z.
왘 Deleting individual digits: Select )
and briefly press n.
The digit to the left of the cursor is de-
leted.
왘 Deleting an entire number:
Select ) and press and hold n until
the number is deleted.
왘 Saving entry: Select ?.
왘 Canceling an entry: Select “Back”.
If you have already entered data, a
prompt will appear asking whether the
entry should be saved.
왘 Select “Yes” or “No”.
The entry will either be saved or
not, depending on your selection.
i
This function is used to add a telephone
number to an existing address book entry. The
telephone number can be entered manually.
i
All entries with the symbol or without a
symbol are address book entries.
i
“Add Number” does not function if you have
selected the main entry for an address book en-
try with subentries.
컄컄
To Next Page
Loading...
Need help?
General
