248
Control systems
COMAND navigation system (destination memory)
1 Selected data field with input mark
(cursor)
2 Input characters
왘 Entering data: Proceed as described
in the “Changing the data field” operat-
ing step in the “Creating a new address
book entry” section (
컄 page 164).
Assigning a destination to an address
book entry
왘 Select “Assign Address Book Entry”.
왘 Select desired category, e.g. “Home”.
The menu appears for searching for an
address book entry.
왘 Select desired address book entry. Pro-
ceed as described in the “Searching for
an address book entry” section
(
컄 page 166).
If the selected address book entry does
not yet contain any navigable address
data, COMAND saves the data.
If the selected address book entry al-
ready contains navigable address data,
you will see a question asking you if the
previous data should be overwritten.
왘 Select “Yes” or “No”.
If you select “Yes”, COMAND saves the
data.
i
This function assigns the complete, naviga-
ble address data to an already existing address
book entry. You can then select this entry in the
address book and start navigation to the address
from there.
컄컄
To Next Page
Loading...
Need help?
General
