256
Control systems
COMAND system settings
왘 Setting value: Rotate ymz or
slide qmr.
왘 Saving setting: Press n.
Setting the time zone and switching be-
tween Daylight Saving Time and stan-
dard time
왘 Setting time zone: Select “Vehicle”
“System Settings” “Time” “Time
Zone”.
The country list appears. The dot R in
front of a list entry indicates the cur-
rent setting.
왘 Select the country in which you are cur-
rently driving.
A time zone list may also be displayed,
depending on the country selected.
왘 Select desired time zone.
Subsequent operation depends on:
앫 whether your navigation system has
GPS reception
앫 which country you have previously set
You may either:
앫 manually switch between “Daylight
Savings Time (Summer)” and “Standard
time (Winter)” in a list
or
앫 switch automatic Daylight Saving Time
to standard time changeover (and vice
versa) on or off
왘 Switching manually: Select “Daylight
Savings Time (Summer)” or “Standard
time (Winter)”.
The dot R in front of a list entry indi-
cates the current setting.
왘 Switching automatic changeover on
or off: Select “Automatic Daylight Sav-
ings Time”.
You have switched the function on or
off. A checkmark appears when the
function is switched on.
왘 Saving setting and exit the menu:
Slide omp.
i
The increment value for setting the minutes
depends on the situation. If GPS reception is
available, it is 30 minutes. If GPS reception is not
available, it is one minute.
i
The correct time zone and Daylight Saving
Time/standard time must be set for the follow-
ing navigation system functions to operate cor-
rectly:
앫 Route guidance on routes with time-depen-
dent traffic guidance
앫 Calculation of estimated arrival time
i
Availability of the automatic daylight saving
time feature depends on the country selected.
i
If you have switched off the automatic
changeover function, you must change Daylight
Saving Time to standard time and vice versa
yourself.
컄컄
To Next Page
Loading...
Need help?
General
