297
Control systems
Instrument cluster control system
왘 Press s or # to start dialing.
If several entries are present for the
same name, they are all shown.
왘 Select the desired entry.
왘 Press s or # to start dialing.
The message “Connecting call…” ap-
pears on the multifunction display, as
well as the dialed telephone number or
name as long as it is stored in the
phone book.
The dialed number is saved in the “Di-
aled numbers” list.
Once a connection has been estab-
lished, the name appears on the multi-
function display, provided that it has
been stored in the phone book, other-
wise the dialed telephone number ap-
pears.
Redialing
The control system stores the most recent-
ly dialed phone numbers. This eliminates
the need to search through your entire
phone book.
왘 Log on to the network (컄 page 295).
왘 Press s to switch to the number
and/or name last dialed in the redial
memory.
왘 Press % or $ to select the de-
sired number and/or name.
왘 Press s or # to start dialing.
Once a connection has been estab-
lished, the name appears in the multi-
function display, provided that it has
been stored in the phone book, other-
wise the dialed telephone number ap-
pears.
Answering a call
When your telephone is ready to receive
calls, you can answer a call at any time
with the ignition on. When you are in the
“Telephone” menu, you will see the follow-
ing message on the multifunction display:
왘 Press s.
Ending a call or rejecting an incoming
call
왘 Press t.
i
The caller’s number appears only if it is
transmitted.
The caller’s name appears only if the number and
the name are stored in the phone book.
To Next Page
Loading...
Need help?
General
