52
Getting started
Driving
Starting with KEYLESS-GO*
You can start your vehicle without the
SmartKey in the starter switch using the
KEYLESS-GO start/stop button on the
gear selector lever.
For information on turning off the engine
with KEYLESS-GO, see “Locking with
KEYLESS-GO*” (
컄 page 62).
The SmartKey with KEYLESS-GO must be
located in the vehicle.
KEYLESS-GO start/stop button
1 USA only
2 Canada only
왘 Make sure the gear selector lever is set
to P.
왘 Depress the brake pedal during the
starting procedure. Do not depress
accelerator.
The selector lever lock is released.
왘 Press KEYLESS-GO start/stop
button 1 once.
The engine starts if the SmartKey with
KEYLESS-GO is in the vehicle.
Starting difficulties
If the engine does not start as described,
carry out the following steps:
왘 If you are starting the engine with the
SmartKey, turn SmartKey in starter
switch to position 0 and repeat starting
procedure.
왘 If you are starting the engine with
KEYLESS-GO: Close any doors that
may be open to allow for better detec-
tion of the SmartKey with
KEYLESS-GO.
Or:
Start the engine with the SmartKey as
radio signals from another source may
be interfering with the SmartKey with
KEYLESS-GO.
왘 Repeat the starting procedure
(
컄 page 51). Remember that extended
starting attempts can drain the battery.
왘 Get a jump start (컄 page 423).
Warning! G
As long as the SmartKey with KEYLESS-GO
is in your vehicle, the vehicle can be started.
Therefore, never leave children unattended
in the vehicle, as they could otherwise acci-
dentally start the engine.
When leaving the vehicle, always take the
SmartKey with KEYLESS-GO with you and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle.
To Next Page
Loading...
Need help?
General
