Control panel for THERMATIC automatic climate control (2-zone)
:
To activate/deactivate air-recirculation mode (Y page 166)
;
To demist the windscreen (Y page 164)
=
To switch the ZONE function on/off (Y page 164)
?
Display
A
To set climate control to automatic mode (Y page 162)
B
To activate/deactivate cooling with air dehumidification (Y page 161)
C
To switch the rear window heating on/off (Y page 165)
D
To switch climate control on/off (Y page 160)
E
To set the temperature, right (Y page 163)
F
To set the air distribution (Y page 163)
G
To set the airflow (Y page 164)
H
To set the temperature, left (Y page 163)
Information about using THERMATIC
automatic climate control
Automatic climate control
The following contains notes and recommen-
dations on optimum use of THERMATIC auto-
matic climate control.
R
Activate climate control using the à and
¿ buttons. The indicator lamps above
the à and ¿ buttons light up.
R
Set the temperature to 22 †.
R
Only use the "Windscreen demisting" func-
tion briefly until the windscreen is clear
again.
R
Only use air-recirculation mode briefly, e.g.
if there are unpleasant outside odours or
when in a tunnel. The windows could oth-
erwise mist up as no fresh air is drawn into
the vehicle in air-recirculation mode.
R
Use the ZONE function to adopt the tem-
perature settings on the driver's side for
the front-passenger side as well. The indi-
cator lamp above the á button goes
out.
R
Vehicles with COMAND Online: if you
change the settings of the climate control
system, the climate status display appears
for approximately three seconds at the bot-
tom of the screen in the COMAND display.
See also the separate COMAND Online
operating instructions. You will see the cur-
rent settings of the various climate control
functions.
Overview of climate control systems
157
Climate control
To Next Page
Loading...
Need help?
General
