In particular, the following conditions must
be complied with:
R
only approved wavebands may be used.
R
observe the maximum permissible out-
put in these wavebands.
R
only approved aerial positions may be
used.
Excessive levels of electromagnetic radiation
may cause damage to your health and to the
health of others. The use of an exterior aerial
takes into consideration the scientific discus-
sion surrounding the possible health risk
posed by electromagnetic fields.
Observe the notes on operating mobile
phones (Y page 353).
The following aerial positions may be used for
the correct installation of RF transmitters:
Saloon: approved aerial positions
:
Front roof area
;
Rear roof area
=
Rear wing
?
Boot lid
Estate: approved aerial positions
:
Front roof area
;
Rear roof area
=
Rear wing
i
When fitting an aerial on the front roof
area of vehicles with a sliding sunroof,
observe the sweeping range of the roof.
On vehicles with panorama sliding sunroof,
fitting an aerial to the front or rear roof area
is not permitted.
On the rear wing, it is recommended that
you position the aerial on the side of the
vehicle closest to the centre of the road.
Use Technical Specification ISO/TS 21609
(Road Vehicles – "EMC guidelines for fitting
aftermarket radio frequency transmitting
equipment") when retrofitting RF (radio fre-
quency) transmitters. Comply with the legal
requirements for add-on parts.
If your vehicle has fittings for two-way radio
equipment, use the power supply or aerial
connections intended for use with the basic
wiring. Be sure to observe the manufacturer's
additional instructions when installing.
Deviations with respect to wavebands, maxi-
mum transmission outputs or aerial positions
must be approved by Mercedes-Benz.
Vehicle electronics
467
Technical data
Z
To Next Page
Loading...
Need help?
General
