Work schedules
Changing the engine oil and filter
Temperature for oil and filter change
Only change the engine oil when the engine
is at normal operating temperature.
Oil filter replacement
!
Make sure that no foreign objects enter
the filter housing. Never wipe the filter
housing out because lint or dirt can enter
the oil circuit.
X
Unscrew oil filter cap : using a socket
spanner insert (SW 36). Allow the oil to
drain from the filter housing.
X
Remove oil filter cap : with oil filter ele-
ment = and unclip oil filter element = by
pressing in a sideways direction.
X
Replace sealing ring ; on cap :. Lightly
grease the sealing ring.
X
Insert new oil filter element =
into
oil filter
cap : and press until it clips into place.
X
Screw on oil filter cap : with the oil filter
element and tighten. Tightening torque:
25 Nm.
Siphoning and draining engine oil
H
Environmental note
Dispose of engine oil and filters in accordance
with the applicable regulations for your loca-
tion.
i
Only siphon off/drain engine oil with the
engine at normal operating temperature.
Example: OM 926 LA
:
Filler neck
;
Oil dipstick
X
To siphon off engine oil: pull out oil dip-
stick ;.
X
Insert the extractor system into the guide
tube, using an O-ring to seal it.
X
Siphon off the engine oil through the guide
tube.
i
Observe the extraction pump operating
instructions.
G
WARNING
Hot engine oil escaping under pressure can
scald your skin and eyes.
Wear suitable protective gloves, protective
clothing and safety goggles.
62
Work schedules
Notes on maintenance
To Next Page
Loading...
Need help?
General
