Mercury Security MR16out User Manual

Mercury Security Corporation © 2009 MR16out DOC 10107-0010 REV 2.01 Page 4
Jumpers:
JUMPER
DESCRIPTION
J1
RS-485 termination, install in first and last units only
J2
Not used
J3
2-wire/4-wire select, install in 2W position only
J4
Factory use only
J5
Factory use only
J6
Factory use only
J7
Factory use only
J8
Factory use only
J9
Factory use only
7. Status LEDs:
Power-up: All LED’s OFF
Initialization: Once power is applied, initialization of the module begins
When initialization is completed, LEDs A, B, CT, and BA are briefly sequenced ON then OFF.
Run time: After the above sequence, the LEDs have the following meanings:
A LED: Heartbeat and On-Line Status:
Off-line: 1 sec rate, 20% ON
On-line:
Non-encrypted communication: 1 sec rate, 80% ON
Encrypted communication:
.1 sec ON, .1 sec OFF, .1 sec ON, .1 sec OFF, .1 sec ON, .1 sec OFF, .1 sec ON, .3 sec OFF
A LED Error Indication:
Waiting for application firmware to be downloaded: .1 sec ON, .1 sec OFF.
B LED: SIO Communication Port Status:
Indicates communication activity on the SIO communication port
CT: Cabinet Tamper
BA: Power Fault
LED 1 through 16: Illuminates when output relay OUT 1 (K1), OUT 2 (K2) is energized and so on.

Mercury Security MR16out Specifications

Power

primary power voltage range	12 to 24 Vdc ±10%
primary power maximum current	1100 mA
nominal current at 12 Vdc	850 mA
nominal current at 24 Vdc	450 mA

Relay Contacts

relay contact type	16 Form-C
relay contact rating	5 A @ 30 Vdc
relay contact resistance	resistive

Operating Environment

storage temperature range	-55°C to +85°C
operating temperature range	0°C to +70°C
humidity range	0% to 95% RHNC

Weight and Dimensions

dimension width	6 in (152 mm)
dimension length	8 in (203 mm)
dimension height	1 in (25.4 mm)
weight	14 oz (400 gm) nominal