MAINTENANCE
125
OIL FILLING
1. Remove the oil fill cap and add recommended oil to the
midpoint of the operating range (midpoint of cross hatched
region). Adding approximately 6 liters (6.3 quarts) will bring oil
level to midpoint of cross hatched region.
2. Reinstall oil fill cap.
3. With outboard in water or cooling water flush hose connected,
idle engine for five minutes to check for leaks at the oil filter.
4. Stop engine and check oil level. Refer to Checking and
Adding Engine Oil.
Gearcase Lubrication
When adding or changing gearcase lubricant, visually check for
the presence of water in the lubricant. If water is present, it may
have settled to the bottom and will drain out prior to the lubricant,
or it may be mixed with the lubricant, giving it a milky colored
appearance. If water is noticed, have the gearcase checked by
your dealer. Water in the lubricant may result in premature bearing
failure or, in freezing temperatures, will turn to ice and damage the
gearcase.
Examine the drained gearcase lubricant for metal particles. A small
amount of metal particles indicates normal gear wear. An
excessive amount of metal filings or larger particles (chips) may
indicate abnormal gear wear and should be checked by an
authorized dealer.
To Next Page
Loading...
Need help?
General
