EasyManuals Logo

Mercury 200 Sport-Jet User Manual

Mercury 200 Sport-Jet
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
Starter Motor Will Not Crank the Engine
POSSIBLE CAUSES
20‑amp fuse in the starting circuit is open. Refer to Maintenance.
Jet drive is not shifted into the neutral position.
Battery is weak or the battery connections are loose or corroded.
Ignition key switch failed.
Wiring or an electrical connection is faulty.
Starter motor solenoid or the slave solenoid failed.
Engine Will Not Start
POSSIBLE CAUSES
Lanyard stop switch is not in the "RUN" position.
Battery is not fully charged.
Incorrect starting procedure was used. Refer to Operation.
Fuel is old or contaminated.
Fuel is not reaching the engine.
Fuel tank is empty.
Fuel tank vent is not open or is restricted.
Fuel line is disconnected or kinked.
Fuel filter is obstructed. Refer to Maintenance.
Fuel pump failed.
Fuel tank filter is obstructed.
20‑amp fuse is open. Check the fuses. Refer to Maintenance.
Threaded connection of an air hose is loose.
Ignition system component failed.
Spark plugs are fouled or defective. Refer to Maintenance.
Engine Runs Erratically
POSSIBLE CAUSES
Spark plugs are fouled or defective. Refer to Maintenance.
System setup or adjustments were done incorrectly.
Fuel to the engine is being restricted.
Engine fuel filter is obstructed. Refer to Maintenance.
Fuel tank filter is obstructed.
Antisiphon valve on built‑in fuel tank is stuck.
Fuel line is kinked or pinched.
Injector is plugged.
TROUBLESHOOTING
66 eng

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 200 Sport-Jet and is the answer not in the manual?

Mercury 200 Sport-Jet Specifications

General IconGeneral
BrandMercury
Model200 Sport-Jet
CategoryEngine
LanguageEnglish

Related product manuals