TRANSPORTING
eng 43
Trailering Boat/Outboard
Ensure the outboard is in forward gear before trailering. This
prevents the propeller from spinning freely during transportation.
NOTICE
Shifting into gear at engine speeds above idle will damage the
gearcase. Shifting into gear when the engine is not running can
cause misalign the clutch, preventing proper shifting. Always
shift the gearcase into gear when the engine is operating at
idle. If you must shift while the engine is not operating, rotate
the propeller shaft in the appropriate direction during shifting.
Trailer your boat with the outboard tilted down in a vertical
operating position. If additional ground clearance is required, the
outboard should be tilted up using an accessory outboard
support device. Refer to your local dealer for recommendations.
Additional clearance may be required for railroad crossings,
driveways, and trailer bouncing.
IMPORTANT: Do not rely on the power trim/tilt system or tilt
support lever to maintain proper ground clearance for trailering.
The outboard tilt support lever is not intended to support the
outboard for trailering.
To Next Page
Need help?
General
