MAINTENANCE
eng 75
CLEANING AND WAXING PROCEDURE
1. Before washing, rinse the top cowl with clean water to
remove the dirt and dust that may scratch the surface.
2. Wash the top cowl with clean water and a mild non‑abrasive
soap. Use a soft clean cloth when washing.
3. Dry thoroughly with a soft clean cloth.
4. Wax the surface using a non‑abrasive automotive polish
(polish designed for clear coat finishes). Remove the applied
wax by hand using a clean soft cloth.
Fuel System
FUEL SYSTEM SERVICE INFORMATION
!
WARNING
Fuel is flammable and explosive. Ensure that the key switch is
off and the lanyard is positioned so that the engine cannot
start. Do not smoke or allow sources of spark or open flame in
the area while servicing. Keep the work area well ventilated
and avoid prolonged exposure to vapors. Always check for
leaks before attempting to start the engine, and wipe up any
spilled fuel immediately.
IMPORTANT: Use an approved container to collect and store
fuel. Wipe up any spillage immediately. Material used to contain
spillage must be disposed of in an approved receptacle.
Before servicing any part of the fuel system:
• Stop engine and disconnect the battery.
• Drain the fuel system completely.
• Perform fuel system service in a well‑ventilated area.
• Inspect any completed service work for sign of fuel leakage.
FUEL LINE INSPECTION
Visually inspect the fuel line and primer bulb for cracks, swelling,
leaks, hardness, or other signs of deterioration or damage. If any
of these conditions are found, the fuel line or primer bulb must be
replaced.
To Next Page
Loading...
Need help?
General
