4. Adjust the water flow (if necessary) so excess water continues leaking out
from around the rubber cups to ensure the engine is receiving an
adequate supply of cooling water.
5. Check for a steady stream of water flowing out of the water pump
indicator hole. Continue flushing the outboard for 3 to 5 minutes, carefully
monitoring water supply at all times.
6. Stop the engine, turn off the water, and remove the flushing attachment.
Install the propeller.
Top Cowl Removal and Installation
REMOVAL
1. Unlock the rear latch by pushing lever down.
To Next Page
Loading...
Need help?
General
