Power Trim Fluid
Checking
IMPORTANT: Check the oil level with the sterndrive unit in the full down/in position only.
1. Place the sterndrive unit in full down/in position.
2. Observe the oil level. Level must be between the MIN and MAX lines on the reservoir.
a - Reservoir
b - MIN and MAX lines
3. Fill as necessary with the specified fluid.
Tube Ref No. Description Where Used Part No.
114
Power Trim and Steering Fluid Power trim pump (recommended fluid) 92-858074K01
4. If the specified fluid is not available,10W‑30 oil (obtain locally) can be used.
Filling
1. Remove the fill cap from the reservoir.
NOTE: Fill cap is vented.
2. Add lubricant to bring level to the within the MIN and MAX lines on the reservoir.
Tube Ref No.
Description Where Used Part No.
114
Power Trim and Steering Fluid Power trim pump 92-858074K01
3. Install the cap.
Changing
Power trim fluid does not require changing unless it becomes contaminated with water or debris. Contact your authorized
Mercury MerCruiser dealer.
Battery
Refer to specific instructions and warnings accompanying your battery. If this information is not available, observe the following
precautions when handling a battery.
!
WARNING
Recharging a weak battery in the boat, or using jumper cables and a booster battery to start the engine, can cause serious
injury or product damage from fire or explosion. Remove the battery from the boat and recharge in a ventilated area away
from sparks or flames.
!
WARNING
An operating or charging battery produces gas that can ignite and explode, spraying out sulfuric acid, which can cause
severe burns. Ventilate the area around the battery and wear protective equipment when handling or servicing batteries.
Auxiliary Batteries
Mercury strongly recommends using at least group 27 or 31 type AGM batteries when load shedding devices are used in place
of auxiliary batteries. Boats using JPS are typically large vessels with many DC loads and the minimum group 24 batteries will
not be sufficient.
The use of a load shedding type device is also applicable in place of an auxiliary house battery or when connecting house
loads to the starting battery.
Section 4 - Maintenance
90-8M0128973 eng MAY 2017 Page 55