Tube Ref
No.
Description Where Used Part No.
114
Power Trim and
Steering Fluid
Power trim pump reservoir 92-858074K01
3. Add power trim and steering fluid, if required, to bring the level to the
bottom of the filler neck.
4. Reinstall the fill cap.
NOTE: The fill cap is vented; check it frequently to ensure that the vent is open
and unrestricted.
a - Fill cap
Changing Fluids
See the Maintenance Chart for the lubricant change frequency. The lubricant
should be changed before placing the boat in storage.
Power trim and power steering fluids do not require changing.
CRANKCASE OIL AND FILTER (BOAT IN THE WATER)
IMPORTANT: When changing the oil, make sure that the engine is near
operating temperature. Use only the recommended motor oil (refer to
Specifications).
1. With the engine off but at normal operating temperature, remove the
dipstick.
2. Install the crankcase oil pump onto the dipstick tube.
3. Insert the hose end of crankcase oil pump into an appropriate container
and, using the pump handle, pump until the crankcase is empty.
a - Crankcase oil pump
b - Crankcase oil pump hose
4. Remove the crankcase oil pump.
5. Place a container beneath the oil filter.
MAINTENANCE
eng 55
To Next Page
Loading...
Need help?
General