Mercury 6 SERIES User Manual

CYLINDER BLOCK AND CRANKCASE
90-857138R1 MAY 2000 Page 4B–13
Powerhead Removal
1.Drain out the engine oil.
2.Remove or disconnect the following components:
a.Starter lock rod.
b.Choke wire
c.Throttle Cables
d.Stop switch, oil warning light and oil pressure wire connections
e.Ground wires at the ignition coil and exciter coil wires.
f. Fuel inlet hose.
3.Remove the six powerhead mounting bolts and lift powerhead upwards.
a
a-Bolts (6) M8 x 40 mm
Removing Powerhead Components
1.Remove the following components:
a.Rewind starter assembly.
b.Remove the flywheel following instructions in Section 2A of this manual.
c.Exciter coil and pulsator coil.
d.Ignition coil.
e.Fuel pump and carburetor.

Mercury 6 SERIES Specifications

General

Brand	Mercury
Model	6 SERIES
Category	Outboard Motor
Language	English