Mercury 6 SERIES User Manual

GENERAL INFORMATION
Page 1C-8 90-857138R1 MAY 2000
Propeller Removal/Installation
WARNING
If the propeller shaft is rotated while the engine is in gear, there is the possibility that
the engine will crank over and start. To prevent this type of accidental engine start-
ing and possible serious injury caused from being struck by a rotating propeller,
always shift outboard to neutral position and remove spark plug leads when you
are servicing the propeller
1. Remove the spark plug leads to prevent engine from starting.
2. Shift outboard to neutral position.
N
3. Straighten and remove cotter pin.
a
a-Cotter Pin
4. Place a block of wood between gear case and propeller to hold propeller and remove
propeller nut.
a
b
a-Block of Wood
b-Propeller Nut

Mercury 6 SERIES Specifications

General

Brand	Mercury
Model	6 SERIES
Category	Outboard Motor
Language	English