67
oh
MAINTENANCE
ohd34
Inspection And Maintenance Schedule
BEFORE EACH USE
1. Check that lanyard stop switch stops the engine.
2. Visually inspect the fuel system for deterioration or leaks.
3. Check outboard for tightness on transom.
4. Check steering system for binding or loose components.
5. Remote Control models – Visually check steering link rod fasteners for proper
tightness.
6. Make sure the drive shaft bearing on the jet drive is lubricated. (page 73)
AFTER EACH USE AND AFTER EVERY 10 HOURS OF OPERATION
1. Lubricate the drive shaft bearing on the jet drive. (page 73)
AFTER EACH USE
1. If operating in salt water, wash off all salt deposits and flush out the exhaust
outlet of the jet drive with fresh water.
EVERY 100 HOURS OF USE OR ONCE YEARLY, WHICHEVER
OCCURS FIRST
1. Lubricate all lubrication points. Lubricate more frequently when used in salt
water. (page 73)
2. Inspect and clean spark plugs. (page 76)
3. Check fuel line filter for contaminants. (pages 63 and 64)
4. Check carburetor adjustments, if required. (page 77)
(continued on next page)
To Next Page
Loading...
Need help?
General
