EasyManuals Logo
Home>Mercury>Motherboard>KVM800M Series

Mercury KVM800M Series User Manual

Mercury KVM800M Series
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
14
Motherboard User’s Guide
Floppy Disk Drive
The motherboard ships with a floppy disk drive cable that can support one or
two drives. Drives can be 3.5" or 5.25" wide, with capacities of 360K, 720K,
1.2MB, 1.44MB, or 2.88MB.
Install your drives and connect power from the system power supply. Use the
cable provided to connect the drives to the floppy disk drive connector FDD1.
IDE Devices
IDE devices include hard disk drives, high-density diskette drives, and CD-ROM
or DVD-ROM drives, among others.
The mainboard ships with an IDE cable that can support one or two IDE
devices. If you connect two devices to a single cable, you must configure one of
the drives as Master and one of the drives as Slave. The documentation of the
IDE device will tell you how to configure the device as a Master or Slave device.
The Master device connects to the end of the cable.
Install the device(s) and connect power from the system power
supply. Use the cable provided to connect the device(s) to the Primary IDE
channel connector IDE1 on the motherboard.
Install Other Devices
Install and connect any other devices in the system following the steps below.
SATA1
SATA2
IDE1
IDE2
11
FDD1
1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury KVM800M Series and is the answer not in the manual?

Mercury KVM800M Series Specifications

General IconGeneral
BrandMercury
ModelKVM800M Series
CategoryMotherboard
LanguageEnglish

Related product manuals