• Make sure the valve stays open (to enable the air to get out during
folding).
• Push evenly on the whole boat to let as much air out as possible.
Folding the Boat
• Lay the boat down on the floor.
• Take out the aluminum or wooden floorboards, if applicable. An inflatable
floor can be left in place.
• Fold the boat to the middle of the boat, so that the whole boat is as wide
as the transom (1‑2).
• Bring the back of the side chambers to the middle (3).
• Roll the transom forward. This helps to get the air out. Be sure all valves
are in the open position (4).
IMPORTANT: If you prefer the oars to be in the same pack / sack as the boat
take care that the oars will not damage the pack / sack. Put in the round parts
of the oars first.
ASSEMBLY AND DISASSEMBLY
eng 23
To Next Page
Loading...
Need help?
General