47
CA104
Bottom Of Boat
To maintain maximum speed, the following conditions of the boat bottom should be observed:
• Clean, free of barnacles and marine growth.
• Free of distortion, nearly flat where it contacts water.
• Straight and smooth, fore and aft.
ANTI-FOULING PAINTS
See Anti-Fouling Paint recommendations and related information on previous pages.
IMPORTANT: Refer to CORROSION AND CORROSION PROTECTION for additional information.
CA105
Inspection And Maintenance
Inspect power package often, and at regular intervals, to help maintain its top operating performance, and correct
potential problems before they occur. The entire power package should be checked carefully, including all
accessible engine parts.
Check for loose, damaged or missing parts, hoses and clamps; tighten or replace as required.
Check plug leads and electrical leads for damage.
Remove and inspect propeller. If badly nicked, bent or cracked, see your dealer.
Repair nicks and corrosion damage on power package exterior finish. Use Quicksilver spray paints - see your
Authorized MerCruiser Dealer.
To Next Page
Loading...
Need help?
General