41
CB184
Remote Controls (Console Mounted)
1 Control Handle(s) - Operation of the shift and throttle are
controlled by the movement of the control handle. “Push” the control
handle forward from “Neutral” with a quick firm motion to the first
detent for “Forward” gear. Continue pushing forward to increase
speed. Pull the control handle back from “Neutral” with a quick firm
motion to the first detent for “Reverse” gear. Continue pushing back
to increase speed.
2 Throttle Only Button - Allows engine throttle advancement
without shifting the engine. This is done by disengaging the shift
mechanism from the control handle. The throttle only button can be
depressed only when the remote control handle is in the “Neutral”
position, and should only be used to assist in starting the engine.
3 Control Handle Tension Adjustment Screw - This screw can be
adjusted to “Increase” or “Decrease” the tension on the control
handle (cover must be removed to adjust). This will help prevent
“Creep” of the remote control handle. Turn screw “Clockwise” to
increase tension and “Counterclockwise” to decrease tension.
Adjust to tension desired.
4 Power Trim Switch - See “Power Trim” section for detailed power
trim operating procedures.
5 Trailer Switch - Used to raise drive unit for trailering, launching,
breaching or shallow water operation. See “Power Trim” for detailed
trailer switch operation.
6 Power Trim Adjustment Switches (Used on Three Button
Trim Control Only) - See “Power Trim” section for detailed power
trim operating procedures.
To Next Page
Loading...
Need help?
General