73
CA632
CHECKING DRIVE UNIT OIL
NOTE: Oil level will fluctuate during operation. Oil level should be
checked with cold engine before starting.
1 Check gear lube monitor oil level. Keep oil level at or near FULL
line. If any water is visible at the bottom of monitor or appears at the
oil fill/drain plug and/or if oil appears discolored, contact your
Authorized MerCruiser Dealer immediately. Both conditions may
indicate a water leak somewhere in the drive unit.
IMPORTANT: If more than 2 fl. oz. (59ml) of Quicksilver High
Performance Gear Lube is required to fill monitor, a seal may be
leaking. Damage to drive unit may occur due to lack of
lubrication. Contact your Authorized MerCruiser Dealer for
service.
CB763
CHECKING POWER TRIM PUMP FLUID
Place drive unit in full down/in position.
2 Remove fill cap from reservoir and observe oil level. Level must
be up to, but not over bottom of filler neck. Add Quicksilver Power
Trim and Steering Fluid or SAE 10W-30 motor oil, if required, to bring
level to bottom of filler neck. Replace cap.
A Check that “Cap plug” has been removed from filler neck and
discarded.
B Fill cap is vented; frequently check that vent is open and
unrestricted.
CA633
Fuel Pump Sight Tube Inspection
3.0L Models
3 The engine fuel pump is equipped with a sight tube which gives
visible evidence of a ruptured fuel pump diaphragm.
If fuel is visible in tube, fuel pump should be replaced by your
Authorized MerCruiser Dealer immediately.
To Next Page
Loading...
Need help?
General