23
4 Assembly of the Instrument
The XDS Analyzer will be assembled and installed by a trained representative of Metrohm. This
person will perform a full suite of diagnostics to verify correct operation, and will explain basic
operating points. Assembly information is given as a guide for the user, should re-assembly ever be
required due to an instrument move or for other reasons.
Verify that the following items have been received in good condition:
• Metrohm XDS Monochromator
• MultiVial module
• Vision Spectral Analysis Software (Vision Manual is on CD)
• Spare Lamp
• Accessory Kit, containing cords, cables, standard tray, and other required items
• Safety Manual for CE certification
• Instrument Test Results Packet
(Packaging of items may vary from that shown.)
The serial number of the instrument and module are located on serial plates on the left side, when
facing the instrument. These serial numbers should match the serial numbers marked on the shipping
papers.
When using Vision software, the software will automatically read the monochromator serial number.
The module serial number must be entered manually, and is located on the module serial number
plate on the left side of the module, facing the instrument.
To Next Page
Loading...
Need help?
General
