Service Manual_2018-V1.0
20
4. Installation specification
4.1 Installation requirements
WARNING: Please cut off water source before replacing filters. Never plug filters in water
running state.
4.2 Pipeline and cartridge installation
1. Open the top of the packing case, take out the top foam and its accessories (include 4
filters and connector).
2. Put the accessories aside.
3. Unpack the product, install the water collector.
4. Take out the quick joint, and install it on the water pipe.
5. Use the after sale accessory—filter flushing tip, the arrow direction is the water flow
direction, insert the PE pipe in the quick joint.
6. Insert the C1 active carbon filter into the filter flushing tip, tighten it by turning
anticlockwise, and open the water tap to flush the filter till it doesn't discharge black water,
for about 10min; with the same method, flush the ultrafiltration membrane filter till it
discharges clear water, for about 10min. Take the same step to flush the C2 active carbon
filter-F1.
7. Install the clean filter in the product, hold the filter with the left hand and enclosure of filter
with the right hand, and insert it upwards in the filter, tighten it by turning anticlockwise, the
installation order is: PP sediment filter-F1→C1 active carbon filter-F1→RO reverse osmosis
filter-F1→C2 active carbon filter-F1
To Next Page
Loading...
Need help?
General
