Midea R410A Tropical ClimaCreator Series Rooftop Package 220V 3Ph 60Hz MCAC-RTT6S-201701
109
Step 2: Press to adjust wired controller setting above room temperature. The Aux. heating
system will begin to operate. The display will show STG1, EMMER to indicate that the Aux.
heating system is operating.
Step 3: Adjust temperature setting to 2°C above room temperature. The auxiliary heat system
should begin to operate and the display should show STG1+2.
Step 4: Press to adjust the wired controller below room temperature. The Aux. heating system
should stop operating.
5) Day and time setting
The LCD will show this following figure information when batteries are first installed. The
temperature will update after a few seconds. During time and day setting mode, the temperature
displays will go blank.
Examples: Set the wired controller to the current time of 2:16 PM on Saturday.
Step 1: Press TIME to enter time and day setting mode. The current hour and AM / PM indicator
will be flashing.
Press UP or DOWN to change the hour up or down to the current hour.
Notes: The AM / PM indicator, as the display will change at 12 AM and 12PM.
Step 2: Press TIME again to change from hour setting to minute setting. The current minute will
be flashing.
Press UP or DOWN to change the minute up or down to the current minute.
To Next Page
Loading...
Need help?
General
