Indoor Unit Disassembly 8
2.2 Electrical parts
Note: Remove the front panel (refer to 1. Front panel) before disassembling electrical parts.
Procedure Illustration
1) Remove the fi xing screw and then
remove the cover of electronic box and
the terminal cover (see CJ_MA_011).
2) Pull out the room temperature sensor
(T1) and the coil temperature sensor
(T2) (see CJ_MA_012).
3) Remove the two screws used for the
ground connection (see CJ_MA_012).
CJ_MA_011
CJ_MA_012
Note: This section is for reference only. Actual unit appearance may vary.
T1 Sensor
Ground Screws
T2 Sensor
Fixing Screw
Electronic Cover
To Next Page
Loading...
Need help?
General