Steamer
39
The B3847 steam ironing system is
equipped with a steamer in addition to
the iron. The steamer is available as
an optional accessory for the B3312
and B3826 steam ironing systems.
The steamer makes ironing hanging
garments easier, e.g. dresses and
jackets. It comes with a removable
brush attachment for lifting the
fibres.
The steamer weighs less than the iron
and also does not have a hot soleplate,
therefore eliminating the risk of shiny
patches if it accidentally comes into
contact with the fabric.
The steamer can also be used when the
appliance is folded up.
The steamer supplied with earlier
steam ironing systems (B1xxx/B2xxx)
cannot be used with this appliance.
Connecting the steamer
You can also plug the steamer into the
steam connection of the ironing
system as an alternative to the iron.
Disconnect the iron from the steam
connection
The iron soleplate is still very hot
after use!
Avoid direct contact.
Place the iron on its resting surface
and let it cool down completely
before you store it away.
Do not pull on the steam hose!
Always pull on the plug at the end of
the steam hose when disconnecting
it from the steam hose connection.
Pull back the slider located on the
side of the steam hose plug.
Hold the slider back.
Withdraw the plug from the steam
connection.
Now you can connect the steamer to
the steam connection.