Miele B 3312 User Manual

Problem solving guide
66
Troubleshooting
Issue Cause and remedy
The steam ironing
system cannot be
switched on.
The steam ironing system does not have any power.
 Check that
– the plug is inserted into the wall socket and that
the socket is switched on.
– the fuse in your fuse panel has not tripped.
After an interruption to
the power supply, the
steam ironing system
does not work any
more.
The steam ironing system is switched off
 Use the  button on the control panel to switch
the steam ironing system on.
If a power cut occurred during the automatic rinse,
the cycle will be repeated when the steam ironing
system is switched on again.
If the power cut occurred during descaling, the
process will be resumed from the stage at which it
was interrupted when the appliance is switched on
again.
The height of the
ironing board cannot be
adjusted.
The ironing board is not locked into place on both
sides of the tower.
 Use both hands to pull the ironing board up and
into the horizontal position until the locking
mechanism audibly clicks into place on both sides
of the tower (see “Assembly”).
The steam ironing
system cannot be
dismantled.
The steam ironing system is not in its lowest working
position.
 Adjust the steam ironing system to its lowest
working height (see “Dismantling”).
The residual water drawer is not inserted completely
and is not locked in place.
 Push the residual water drawer back into the tower
until it locks into place.
 Then adjust the steam ironing system to its lowest
working height (see “Dismantling”).

Miele B 3312 Specifications

General

Brand	Miele
Model	B 3312
Category	Iron
Language	English