Miele B 3312 User Manual

Problem solving guide
72
Message Cause and remedy
Message in the display:
Inlet fault, boiler Switch
off/on
There is a fault.
 Press the button to switch the steam ironing
system off and then back on again.
After the cool-down phase, the steam ironing system
is carrying out an additional rinse function and is
attempting to correct the fault itself. The cool-down
phase may take up to 3hours.
 Remove the residual water drawer if you are
prompted to do so by the appropriate message in
the display.
 Empty and dry the residual water drawer.
 Push the residual water drawer back in the tower
until it clicks into place.
There is a fault.
 If the fault message continues to be displayed,
contact your Miele dealer.
Message in the display:
Pressure switch fault.
Switch off/on
There is a fault.
 Press the  button to switch the steam ironing
system off and then back on again.
 If the fault continues to be displayed, contact your
Miele dealer.
Message in the display:
Boiler fault, warm Switch
off/on
There is a fault.
 Press the  button to switch the steam ironing
system off and then back on again.
 If the fault continues to be displayed, contact your
Miele dealer.
The steam generator is contaminated with water
containing too much limescale or salt.
 Start the descaling process (see „Starting the
descaling process early“). To avoid this problem in
the future, the preset water hardness level can be
set one level higher, (e.g., from Level 4 to Level 5
(see „Water hardness setting“).
 If the fault continues to be displayed, contact your
Miele dealer.

Miele B 3312 Specifications

General

Brand	Miele
Model	B 3312
Category	Iron
Language	English