Switching the coffee machine on and off
24
Switching on
Switch the master switch on the left-
hand side of the machine to the "I"
position.
Touch the On/Off sensor.
The appliance will begin rinsing after
the heating-up phase. Hot water will
come out of the central spout.
When Select drink appears in the display,
you can prepare drinks.
If the coffee machine still has an
operating temperature which is higher
than 60°C, rinsing will not take place.
If you do not touch any sensors or run
the maintenance programme, the
display will switch itself off after
approx.7minutes to save energy.
The right-hand LED will flash on and off
as long as the machine is switched on.
Touch any one of the sensors to wake
the machine up again to make a
drink.
Switching off
Touch the On/Off sensor.
After a coffee has been dispensed, the
pipework will be rinsed before the
machine switches off.
If a drink has been made using milk, the
message Place milk pipe in drip tray will
appear in the display.
Insert the end of the milk pipe into the
aperture in the drip tray, then touch
OK.
If the milk system is not rinsed out
before switching off, it will have to be
rinsed the next time the machine is
switched on.
Switching off for longer
periods of time
If the coffee machine is not going to be
used for a longer period of time, e.g. if
you are going on holiday:
Empty the drip tray, the waste
container and the water container.
Clean all parts thoroughly, including
the brew unit.
Switch the machine off with the
master switch and at the wall socket.
The time of day will not be saved. It
will have to be reset next time the
machine is switched on.
To Next Page
Loading...
Need help?
General
