Cleaning and care
57
Remove the brew unit and
wash by hand
Danger of injury!
Disconnect the coffee machine from
the power supply before cleaning.
Clean the brew unit by hand only
using warm water. Do not use
washing-up liquid. The moving
parts of the brew unit are lubricated.
Washing-up liquid will damage the
brew unit.
Clean the brew unit once a week.
Open the door.
Press the button under the handle of
the brew unit and, whilst doing so,
turn the handle to the left.
Carefully pull the brew unit out of the
coffee machine.
If you cannot remove the brew unit or
can only do so with difficulty, the brew
unit is not in the correct position (See
"Problem solving guide").
When you have removed the brew
unit, do not change the position of
the handle on the brew unit.
Clean the brew unit by hand under
warm running water without using
washing-up liquid.
Wipe any remaining coffee off the two
filters. One filter is located in the
funnel and the other to the left of the
funnel.
Dry the funnel to prevent ground
coffee sticking to it the next time a
coffee is prepared.
Carefully clean the inside of the
coffee machine.
Make sure you regularly remove any
damp ground coffee residues to
prevent the build-up of mould.
Useful tip: Use your vacuum cleaner to
remove dry ground coffee residues.
To replace the brew unit, proceed in the
reverse order:
Push the brew unit back into the
coffee machine, making sure it is
straight.
To Next Page
Need help?
General
