Miele CS 1018 G User Manual

Cleaning and care
29
Stainless steel frame/control
panel
 Clean the frame and the control panel
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
You can also use a ceramic and
stainless steel cleaning agent. We
recommend using a stainless steel
conditioning agent to help prevent
resoiling (see "Optional accessories").
Do not use a ceramic and stainless
steel cleaner or stainless steel
conditioning agent on the printing.
This would rub the printing off.
These areas should only be cleaned
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
Operating controls
 Clean the control(s) with a solution of
warm water and a little washing-up
liquid applied with a soft sponge.
Stubborn soiling should be soaked
first.
 Dry the control(s) with a clean cloth.
Stainless steel surfaces
Do not clean the area between the
cooktop and the worktop with sharp,
pointed objects.
This could damage the seals.
Soiling, particularly salty food or
liquid and olive oil, can cause
damage if left on the printed surfaces
for a long time.
Remove any soiling which comes
into contact with the printed flame
symbols straight away.
Stainless steel cleaning agents rub
off the printed symbols.
Do not use stainless steel cleaning
agents on printed symbols.
 Clean stainless steel surfaces with a
solution of warm water and a small
amount of washing-up liquid applied
with a soft sponge. In the case of
stubborn dried-on soiling, soak first.
If necessary, the rough side of a non-
scouring sponge can be used.
 Finally, dry with a clean soft cloth.
Useful tip: The Miele conditioning
agent for stainless steel can be used
after cleaning to help keep your
appliance looking good (see "Optional
accessories"). Apply sparingly with a
soft cloth following the instructions on
the packaging.

Miele CS 1018 G Specifications

General

Brand	Miele
Model	CS 1018 G
Category	Hob
Language	English