Safety instructions for installation
35
Fit the wall units and rangehood before fitting the CombiSet to avoid damaging
it.
The veneer or laminate coatings of worktops (or adjacent kitchen
units) must be treated with 100°C heat-resistant adhesive which will
not dissolve or distort. Any splashbacks must be of heat-resistant
material as well.
An electric fryer must not be installed directly next to a gas
cooktop as the gas flames could ignite the fat in the fryer. It is
essential to maintain a distance of at least 288mm between these
two appliances.
The CombiSet must not be installed over a fridge, fridge-freezer,
freezer, dishwasher, washing machine, washer-dryer or tumble dryer.
When installing the CombiSet, make sure that the gas hose and
electrical connection cable cannot come into contact with hot
appliance parts.
The electrical cable and any flexible gas connection pipes must be
installed in such a way so that they do not come into contact with
any moving kitchen parts (e.g. a drawer), and cannot become
trapped.
Observe carefully the safety clearances listed on the following
pages.
All dimensions in this instruction booklet are given in mm.
To Next Page
Loading...
Need help?
General